I have decided not to include a manual page for
cowboy_stream_h at this point because it clashes
with the cowboy_stream manual page. This decision
will be revisited in the future.
Before this commit we had an issue where configuring a
Websocket connection was simply not possible without
doing magic, adding callbacks or extra return values.
The init/2 function only allowed setting hibernate
and timeout options.
After this commit, when switching to a different
type of handler you can either return
{module, Req, State}
or
{module, Req, State, Opts}
where Opts is any value (as far as the sub protocol
interface is concerned) and is ultimately checked
by the custom handlers.
A large protocol like Websocket would accept only
a map there, with many different options, while a
small interface like loop handlers would allow
passing hibernate and nothing else.
For Websocket, hibernate must be set from the
websocket_init/1 callback, because init/2 executes
in a separate process.
Sub protocols now have two callbacks: one with the
Opts value, one without.
The loop handler code was largely reworked and
simplified. It does not need to manage a timeout
or read from the socket anymore, it's the job of
the protocol code. A lot of unnecessary stuff was
therefore removed.
Websocket compression must now be enabled from
the handler options instead of per listener. This
means that a project can have two separate Websocket
handlers with different options. Compression is
still disabled by default, and the idle_timeout
value was changed from inifnity to 60000 (60 seconds),
as that's safer and is also a good value for mobile
devices.
In particular the cowboy_sub_protocol is subject to change soon.
Also the cowboy_stream behavior is going to be left hidden in
this release and enabled when it becomes easier to chain them.
